ASTM F3023-18(2025)【中文翻译+PDF原文】
Standard Test Methods for Evaluating Design and Performance Characteristics of Stationary Upright and Recumbent Exercise Bicycles and Upper and Total Body Ergometers
固定式直立和卧式健身自行车以及上肢和全身测力计的设计与性能特性评估标准试验方法
standard by ASTM International, 02/01/2025.
LANGUAGES: English+Chinese【英文原文+中文翻译】
Historical Editions: ASTM F3023-18, ASTM F3023-13
Description
1.1 These test methods specify procedures and equipment used for testing and evaluating stationary exercise upright and recumbent bicycles and ergometers for compliance to Specification F1250. Both design and operational parameters will be evaluated. Where possible and applicable, accepted test methods from other recognized bodies will be used and referenced. In the case of a conflict between this document and Specification F1250, Specification F1250 takes precedence.
展开剩余63%1.2 Requirements-Stationary exercise bicycles and ergometers are to be tested for the parameters specified in Specification F2276 and Test Methods F2571 and the following parameters unique to this equipment:
1.2.1 Seat post construction and loading,
1.2.2 Handlebar construction and loading,
1.2.3 Pedal construction and loading,
1.2.4 Crank arm and enclosure entrapment,
1.2.5 Seat back support loading,
1.2.6 Stability,
1.2.7 Direct Drive Exercise Bicycle Pedal Endurance,
1.2.8 Warnings, and
1.2.9 Documentation.
1.3 This test method2 contains additional requirements to address the accessibility of the equipment for persons with disabilities.
1.4 Units-The values stated in SI units are to be regarded as standard. The values given in parentheses are mathematical conversions to inch-pound units that are provided for information only and are not considered standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
发布于：山东省股王配资提示：文章来自网络，不代表本站观点。
